www.beck-ipc.com
www.beck-ipc.comwww.beck-ipc.com  | ImprintImprint
FAQFAQ  | SearchSearch  |
RegisterRegister   |LoginLogin

Verwendung von JTAG

Questions and discussions about the hardware of the IPC@CHIP® products SC1x5.

Verwendung von JTAG

Postby Thomas Rebhan » 18.04.2017, 15:37

Hallo,

für welche Zwecke kann das JTAG-Interface verwendet werden?
Hat das Debuggen über JTAG Vorteile gegenüber der Ethernet-Verbindung?

mfg
Thomas Rebhan

Re: Verwendung von JTAG

Postby dippel » 19.04.2017, 18:05

Hello,

the JTAG may be used for BST (Boundary Scan Test), debugging and low-level programming.
One advantage of JTAG-debugging/programming is that it´s work without ETH functionality.
Please Note: BECK IPC does not offer any JTAG adaptor or the corresponding SW-Debugger.
R. Dippel
Leiter Entwicklung
BECK IPC

Return to SC1x5


Who is online

Users browsing this forum: No registered users and 1 guest


cron