www.beck-ipc.com
www.beck-ipc.comwww.beck-ipc.com  | ImprintImprint
FAQFAQ  | SearchSearch  |
RegisterRegister   |LoginLogin

FK61-WL01 Connector Board design

Questions and discussions about IPC@CHIP® hardware addons (e.g. FK61-WL01)
Dear Beck

Just received the FK61 and it works fine. But ... I would also like to use COM2 to read a GPS. As far as I can judge it, it looks as though only the 3.3V is used of connector S31. Is that correct? If so .... can I disconnect this connector and connect my GPS again?

And .... or ..... do you have a board design for the FK60 connector board (FB60 - WL01) for me?

Regards

Peter Bruinink
Peter Bruinink
ChampionChip BV
the Netherlands
p.bruinink@championchip.com

Postby Markus Bartat » 14.11.2006, 15:03

Hello Mr Buinink,

the COM2 pins are not connected. Only 3,3V and Gnd Pin are used.
You should be able to conncet your GPS on COM2. You will find a board design under http://www.beck-ipc.com/files/ipc/documentation/diagrams/CD_FB60-WL01_V10.pdf.
There is a typo on this sheet. Instead of Connector S33 , it must be S31.

Best regards

3.3V on S31

Postby BruininkP » 14.11.2006, 15:25

Dear Markus

Thank you for your answer.

Would it harm when I disconnect this 3.3V, as I also use it for the GPS

Regards

Peter Bruinink
Peter Bruinink
ChampionChip BV
the Netherlands
p.bruinink@championchip.com

Postby Marco Nesseldreher » 16.11.2006, 12:08

Hello Mr Buinink

All 3.3V signals on the FB60-WL01 board are connected together. You can disconnect the connection of S31. The WL01 will be supplied through the other 3.3V connections.

regards

Marco Nesseldreher
Marco Nesseldreher
Hardwareentwicklung
Beck IPC GmbH

Return to Hardware Addons


Who is online

Users browsing this forum: No registered users and 1 guest


cron