www.beck-ipc.com
www.beck-ipc.comwww.beck-ipc.com  | ImprintImprint
FAQFAQ  | SearchSearch  |
RegisterRegister   |LoginLogin

Crash the file transfer via FTP client chipstoll with sc143

Questions and discussions about the hardware of the IPC@CHIP® products SC123, SC143, SC23 and SC24.
Hello,
I use a SC143 and DK60 card.
After loading the autoexec and prog.exe, I can not transferring a program through chipstool and 2 output LEDs light ( near sw7).
I can not change my IP.
I can not flash the RTOS.
If I press the reset button, I connect (via telnet ftp-chipstool), but at the time of a transfer that failed!
Have you any idea?
Thanks

Hello,

please have a look to this FAQ thead:
http://forum.beck-ipc.com/viewtopic.php?f=15&t=13139&start=0

Regards,
André Pribil
Software Development
Beck IPC GmbH

Hello,
Thanks for you response.
But now , i don't communicate with the chip.
Serial port no communicate.
HTTP no communicate.
Have you a solution for my problem.
Thanks

Return to SC1x3/SC2x


Who is online

Users browsing this forum: No registered users and 2 guests


cron